-Zoey
Before LED batten lights are made into finished products, they will go through a series of tests, including battery tests and the overall test of light. And the aging test is one of the very important one.
The aging test refers to simulating the situation of the product in the actual use conditions, and observing whether the LED light can not work normally after power supply, and whether the emergency light can work normally. Aging test is of great help to the quality inspection of LED triproof light.
As a professional LED waterproof fixture provider in the market, we attach great importance to the aging of light. In terms of equipment, we have fully automatic aging machines and burn-in racks. The following is a brief introduction to the aging process.
1. After passing the full inspection,put the finished product on the test rack, and the line must be correctly connected to the L, N and S ports.
2. Turn on the power supply and check the brightness of the lamp chips to see if it is faulty. If it is an led emergency light, turn off the external power supply to check whether the emergency situation is normal. If it is normal, then proceed to the next test after aging for 8-16 hours.
3. Test the S line switch, and perform this test after aging for 8-16 hours to check whether the S line of the main gate switch is consistent with the normal operation of the LED weatherproof light.
4. Emergency discharge test. This step is required for the LED emergency light to check whether the test board indicator light is normal. The external power is turned off, and the battery discharge time is recorded. Check the emergency time and other faults when the light is off. Restore power to check the situation.At the same time, repeat the discharge test after a period of time to check whether it is normal.
5. Half power test. Set the output terminal of the power supply to half power, observe whether the brightness of the LED linear batten light decreases, and find out the unchanged light and the reason. Set to full power and continue testing.
In addition to the above main tests, there are also process steps such as impact test, sensor test, power-off packaging and pre-packaging quality inspection. Each of our LED vapor light will undergo an aging test and strictly record to ensure the quality of the product.
For further information or technical data, please kindly check product lines from our web(http://www.litechled.com). If you have any new ideas or customized requirements, please feel free to contact us.
We could provide different functions, such as: emergency battery backup, energy saving motion sensor, linkable cable and designs.
Welcome to visit our factory and consult with us!
Contact: Sales Engineer Zoey
Email: sales4@comledtech.com
Post time: Oct-08-2022